MCZ Club Manuel d'instructions télécharger pdf (Page 45)

PELLET STOVES Chapter 4

INSTALLATION AND USE MANUAL

page 45

Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited

7. SAFETY DEVICES AND ALARMS

7.1. SAFETY DEVICES

The stove is fitted with the following safety devices:

 SMOKE TEMPERATURE SENSOR.

Monitors the temperature of the smoke, and gives permission for

start-up or shuts the stove down when the smoke temperature

falls below the preset value.

 PELLET HOPPER TEMPERATURE SENSOR.

If the temperature exceeds the preset safety level, it immediately

shuts down the running of the stove, and has to be reset

manually, after the stove has cooled, before the it will restart.

 ELECTRICAL SAFETY

The stove is protected against violent surges of current by the

main fuse, which is located on the control panel at the rear of the

stove. Other fuses to protect the electronic boards are to be found

on the boards themselves.

 FAILURE OF THE SMOKE EXTRACTION FAN

If the fan stops, the electronic board shuts off the supply of pellets

in good time, and an alarm is displayed.

 BREAKDOWN OF THE REDUCTION MOTOR

If the reduction motor stops, the stove continues to function until

it has cooled down to the minimum level.

 TEMPORARY POWER CUT

If there is a power outage during operation, when the power

comes back on the stove will go into cooling mode and then it will

come back on automatically.

 FAILURE TO LIGHT

If during ignition no flame develops, the stove will go into alarm

condition.

TAMPERING WITH THE SAFETY DEVICES IS

PROHIBITED

It is only after eliminating the cause which gave rise to the

intervention of the safety system, that it is possible to relight

the stove and thus reset the automatic operation of the

sensor. To understand which anomaly has occurred, consult

this manual at paragraph 4.17 which explains what to do

based on the alarm message the stove displays.

ATTENTION

If the stove is not used as described in this instruction booklet,

the manufacturer refuses to accept any responsibility for

damage to persons and property that may arise. The

manufacturer furthermore refuses to accept responsibility for

damage to persons and property arising from the failure to

observe all the rules contained in the manual and in particular:

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 64 65

Commentaires sur ces manuels

Pas de commentaire

MCZ Club Manuel d'instructions Page 45

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles MCZ Club