MCZ Club Manuel d'instructions télécharger pdf (Page 37)

PELLET STOVES Chapter 4

INSTALLATION AND USE MANUAL

page 37

Operation Technical service - Rights reserved MCZ Group S.p.A. - Reproduction prohibited

4.2. PRE-LIGHTING CHECK

Check that all the safety conditions described above have been met.

Make sure you have read and completely understood the contents of

this instruction booklet.

Remove any components which might burn from the firebox and from

the glass (various instructions and adhesive labels).

Check that the grate A is properly positioned and rests correctly on the

base.

After long periods of disuse, remove from the hopper (using

a vacuum cleaner with an extension) any remains of

pellets which have lain there for some time, since they may

have absorbed moisture, which changes their original

characteristics and makes them unsuitable for burning.

4.2.1. Note on first ignition

The first attempt at ignition may not be successful,

since the feeder screw is empty and it is not always

able to fill the grate with required amount of pellets

in time to ensure normal ignition

CANCEL THE ALARM (A02) CONDITION FROM THE

EMERGENCY PANEL (see paragraph 7.2), REMOVE

PELLETS IN THE GRATE AND REPEAT LIGHTING

After repeated attempts at lighting, if there is no flame even though

pellets are flowing normally, check that the grate is correctly

positioned. It must be placed where it adheres perfectly to its

housing and free of any ash incrustations. If after this check no

abnormalities are found, it means that there may be a problem with the

stove components or that installation may not have been carried out

correctly.

REMOVE THE PELLETS FROM THE BURNER AND

CONTACT AN AUTHORISED MCZ TECHNICIAN.

4.3. LOADING THE PELLETS

Fuel is loaded from the upper part of the stove by opening a door. Pour

the pellets in the hopper. Pour the pellets in the hopper; when empty it

holds almost two sacks (about 25 kg)

This is easier if performed in two steps:

 Pour half of the contents into the hopper and wait for the fuel

to settle on the bottom.

 Then pour in the rest

Never remove the protection grille in the hopper.

When filling, do not let the sack of pellets touch any

hot surfaces.

Do not place any type of fuel in the hopper other than

pellets that are compliant with the specifications

provided previously.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 64 65

Commentaires sur ces manuels

Pas de commentaire

MCZ Club Manuel d'instructions Page 37

Commentaires sur ces manuels

Produits connexes et manuels pour Poêles MCZ Club