MCZ Club Guide d'installation télécharger pdf (Page 12)

min.3,5 metri

(A)

(B)

4-FLUE

FOREWORD

This chapter on the Smoke Flue has been produced in reference to the prescriptions of European regulations (EN13384 - EN1443 - EN1856

- EN1457).

The chapter provides indications for installing an ecient and correct smoke ue but is under no circumstances to substitute the

regulations in force, which the qualied technician must be in possession of. Check with local authorities whether there are any restrictive

regulations in force regarding the intake of air for combustion, the smoke extraction system, the ue or the chimney.

The company declines all liability relating to the poor functioning of the boiler if this is due to the use of an insuciently sized ue in

violation of regulations in force.

SMOKE FLUE

The ue or chimney is of great importance for the proper operation of a solid fuel-burning heating appliance with natural draught, as

modern heating appliances have high eciency with cooler ue gasses and consequently less draught, it is therefore essential that the

ue is built up to standard and always kept in perfect working order. A ue that serves a pellet/wood fuelled appliance must be at least

category T400 (or greater if the appliance requires, and resistant to soot res. Smoke must be extracted through a single ue made of

insulated steel (A) or an existing ue that complies with the intended use (B).

A simple air shaft in cement must be suitably lined. In both solutions there must be an inspection cap (AT) and/or inspection hatch (AP)

- FIG.1.

It is prohibited to connect more than one wood/pellet or any other type of appliance (vent cowling...) to the same ue.

FIGURE 1 - SMOKE FLUE

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Pas de commentaire

MCZ Club Guide d'installation Page 12